YASKAWA Varispeed G7 Manuel d'utilisateur télécharger pdf (Page 29)

7 MECHATROLINK-II Commands

 Clear Alarm or Warning (ALM_CLR)

The ALM_CLR command is used to clear the alarm and warning status.

This command changes the status of the slave station. It does not remove the cause of a fault.

After the cause of the alarm or warning has been removed, this command is then used to

clear the status of the alarm or warning.

In the following cases, a warning is generated and the command is ignored.

• If not in phase 2 or 3: Command alarm (A.95)

• If ALM_CLR_MOD is other than a set value: Data setting alarm (A.94)

Note: Inverter alarms cannot be reset while the Inverter RUN command is

ON.

Byte Command Response

1 ALM_CLR ALM_CLR

2 ALARM

3 STATUS

5 ALM_CLR_MOD ALM_CLR_MOD

16 WDT RWDT

ALM_CLR_MOD Description

0 Clears the status of present faults and alarms.

1 2 ... 24 25 26 27 28 29 30 31 32 33 34 ... 51 52

Pas de commentaire

YASKAWA Varispeed G7 Manuel d'utilisateur Page 29