YASKAWA VS-606V7 Series Spécifications Page 1

YASKAWAYA S K A WAMANUAL NO. TOBP C730600 03CUpon receipt of the product and prior to initial operation, read these instructions thoroughly and retai

102.2 Parts ListThe SI-T/V7 Unit contains the following parts.3 Component Names and Settings3.1 Component NamesThe following diagram shows the SI-T/V7

3 Component Names and Settings113.2 Communications Connectors (CN2)The communications connectors connect the SI-T/V7 Unit to the communications lines

123.4 Switch Setting DIP SwitchThe following table shows the SI-T/V7 Unit DIP switch settings.* 1. Invalid if S1-1 is OFF (4 Mbps) and S1-2 is ON (3

3 Component Names and Settings13 Station-number SettingA station number is set by both the S1-3 DIP switch and the S2 rotary switch. Station num-ber

144 Installation and WiringRoute the MECHATROLINK communications cables separately from the main circuit wiring and other power lines.4.1 Installing t

4 Installation and Wiring15Fig. 1 Front of the Inverter Fig. 2 Front of the SI-T/V7 Unit5.5mmCN1CN25.5mmMounting fixtureConnector for SI-T/V7 Unit

164.2 MECHATROLINK Communications Cables Wiring Wire the MECHATROLINK communications cables to the communications connector (CN2).• For communicatio

5 Inverter Setting175 Inverter SettingPerform the following constant setting, whenever necessary, before starting communications between the Inverter

186 Communications Specifications* 1. The baud rate is 4 Mbps for MECHATROLINK-I, and 10 Mbps for MECHATROLINK-II.* 2. For MECHATROLINK-I, a cycle i

Revision HistoryThe revision dates and numbers of the revised manuals are given on the bottom of the back cover.Date of Printing Rev. No. Section Rev

Copyright © 2004 YASKAWA ELECTRIC CORPORATIONAll rights reserved. No part of this publication may be reproduced, stored in a retrieval system, or tra

YASKAWAYASKAWA ELECTRIC CORPORATIONPrinted in Japan December 2004 04-6 2MANUAL NO. TOBP C730600 03C04-8⑥ IRUMA BUSINESS CENTER480, Kamifujisawa,

3IntroductionThank you for purchasing a Vector-control General-purpose VS-606V7 Inverter and a SI-T/V7 MECHATROLINK-I/MECHATROLINK-II Communications I

4Safety PrecautionsCarefully read this manual and all other documentation provided with the product before attempting to install, operate, inspect, or

5 Confirmations upon Delivery Installation and Wiring Settings• Never use an Option Unit that is damaged or missing components.Doing so can result

6Warranty Information Free Warranty Period and Scope Warranty PeriodThis product is warranted for twelve months after being delivered to Yaskawa&apo

7Restrictions• The SI-T Unit was not designed or manufactured for use in devices or systems that may directly affect or threaten human lives or healt

8CONTENTSIntroduction - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - - 3Safety Precautions - - - - - - - - - -

1 Overview91OverviewThe SI-T/V7 Interface Unit is an interface unit that connects to the MECHATROLINK-I or MECHATROLINK-II high-speed field network f