Yaskawa GPD515C-XXXX-CS006 Manuel d'utilisateur télécharger pdf

For GPD515 Adjustable Frequency Drives

Change 0 4/18/97 Page 1 of 6 Doc. No. 02Y00025-0422

Change 1 9/19/00

Traverse Control

FLASH Memory Software Option

Part Number: GPD515C-XXXX-CS006

(1)

With this factory-installed FLASH software, the

GPD515 has the ability to modulate the output

frequency around the set frequency reference.

This function provides an evenly wound roll for

those winding applications that would

experience localized build-ups without this

feature. The terms disturb, p-jump, ribbon

break and wobbulator are also used to

describe this function.

Specifications:

• P-Jump Function / Inertia Compensation

• P-Jump ON/OFF Select

• P-Jump Limit

• Adjustable Duty Cycle

• Sawtooth Waveform Generation / Ribbon

Break

• Percent Trim Adjustment

• Independent P-Jump Adjustment

• Independent Accel/Decel Times

• Control Mode: P-Jump in V/f only

• Serial Communications: DeviceNet,

Profibus, Modbus Plus, Modbus RTU.

This document is an addendum to Technical

Manual TM4515, listing the effect of this soft-

ware on the parameters in the drive and

function descriptions in the manual.

(1) XXXX refers to the base Model Number of

the drive in which the software is installed.

1 2 3 4 5 6

Résumé du contenu

Page 1 - Traverse Control

For GPD515 Adjustable Frequency Drives Change 0 4/18/97 Page 1 of 6 Doc. No.

Page 2 - Change 1 9/19/00

Change 0 4/18/97 Page 2 of 6 Doc. No. 02Y00025-0422Change 1 9/19/00 1.0 Wiring Wire the incoming power, motor, and accessories and

Page 3 - Traverse Param

Change 0 4/18/97 Page 3 of 6 Doc. No. 02Y00025-0422Change 1 9/19/00 3.0 Startup Procedure 1. Perform the start-up procedure using

Page 4 - Enabled

Change 0 4/18/97 Page 4 of 6 Doc. No. 02Y00025-0422Change 1 9/19/00 4.3 New Program Parameters The Traverse (Disturb) function giv

Page 5 - Disturb WF Amp

Change 0 4/18/97 Page 5 of 6 Doc. No. 02Y00025-0422Change 1 9/19/00 Disturb WF Amp P1-02= 0.0 % P1-02 Disturb Waveform Amplit

Page 6 - P1-05= 0.0 Sec

Change 0 4/18/97 Page 6 of 6 Doc. No. 02Y00025-0422Change 1 9/19/00 Neg Slope Time P1-04= 0.0 Sec P1-04 Negative Slope Time S

Commentaires sur ces manuels

Pas de commentaire