YASKAWA VS MINI J7 Manuel d'instructions télécharger pdf (Page 82)

• Selecting Stopping Method

Selects the stopping method when the run command is removed.

• Deceleration to stop (n04 =0)

Upon removal of the FWD (REV) run command, the motor decelerates at the decel rate

determined by the time set to decel time 1 (n17) and DC injection braking is applied

immediately before stop. DC injection braking is also applied when the motor

decelerates by setting the frequency reference lower than minimum output frequency

while the(n14) with FWD (REV) run command remains ON.

If the decel time is short or the load inertia is large, an over voltage (OV) fault may

occur during deceleration. In this case, increase the decel time.

Selecting stopping method (n04)

Setting Description

0 Deceleration to stop

1 Coast to stop

* When frequency reference is changed during running.

1 2 ... 77 78 79 80 81 82 83 84 85 86 87 ... 117 118

Pas de commentaire

YASKAWA VS MINI J7 Manuel d'instructions Page 82