YASKAWA VS MINI J7 Manuel d'utilisateur télécharger pdf (Page 67)

Setting the Local/Remote Mode Chapter 5-3

5-3 Setting the Local/Remote Mode

The J7AZ operates in local or remote mode. The following description

provides information on these modes and how to select them.

Basic Conecpt

Local/Remote Selection Methods

The following two selection methods are available to set the Inverter to local or

remote mode. While the operation command is being input, however, the

Inverter cannot be set to local mode from remote mode or vice versa.

• Select the mode with the LO/RE Key of the Digital Operator.

• Set any one of multi-function inputs 1 through 4 (n36 through n39) to 17 to

set the Inverter to local mode with control input turned ON.

Note If the above setting is made, mode selection will be possible only with multi-

function input, and not with the Digital Operator.

The Inverter always goes into remote mode when the power is turned ON.

Therefore, to operate immediately after power-up, set up the RUN command

and frequency reference settings in remote mode in advance.

Operation mode Basic concept Description

Remote The Inverter in a system operates

according to the control signal of

the host controller.

RUN Command

Selectable from two types and set in n02.

Frequency Reference

Selectable from five types and set in n03.

Local The Inverter in a system operates

independently in this mode so that

the Inverter can be checked

independently.

RUN Command

Starts with the RUN Key of the Digital Operator and

stops with the STOP/RESET Key.

Frequency Reference

Set with the Digital Operator or the FREQ adjuster.

Set with frequency reference selection in local

mode in n07.

1 2 ... 62 63 64 65 66 67 68 69 70 71 72 ... 176 177

Pas de commentaire

YASKAWA VS MINI J7 Manuel d'utilisateur Page 67