YASKAWA SERVO Manuel d'utilisateur télécharger pdf (Page 26)

2.2 Servomotor Installation

2-5

Installation

2.2 Servomotor Installation

2.2.1 Orientation

Servomotors can be installed either horizontally or vertically.

Servomotors with gears can be installed only horizontally, depending on gear lubrica-

tion conditions. Refer to

-V Series Product Catalog (KAEP S800000 42) for details.

2.2.2 Installation Standards

The motor rated specifications (rated output, rated torque, and rated speed) are the

continuous allowable values at an ambient temperature of 40°C when servomotors

are installed with heat sinks.

For more information on heat sinks, refer to

-V Series Product Catalog (KAEP

S800000 42).

When a motor is mounted on a small surface, the motor temperature may rise consid-

erably because of the limited heat radiating abilities of the surface. To restrict the

temperature rise, you should either mount a heat sink or limit the electrical, thermal,

and mechanical stress on the motor (derating). Refer to

-V Series Product Catalog

(KAEP S800000 42) for the relation between heat sink size and derating. The data in

the catalog is given only for reference, as the actual temperature rise depends on how

the heat sink (motor mounting section) is fixed on the installation surface and what

material is used for the motor mounting section. Always check the actual motor tem-

perature.

If the servomotor is covered, or if a heating element is installed near the servomotor,

the motor temperature may rise considerably. In this case, take following counter-

measures.

• Reduce the load ratio.

• Reconsider the motor heating conditions.

• Install a cooling fan to forcedly cool the motor.

1 2 ... 21 22 23 24 25 26 27 28 29 30 31 ... 108 109

Pas de commentaire

YASKAWA SERVO Manuel d'utilisateur Page 26