Yaskawa MP2600iec Manuel d'utilisateur télécharger pdf (Page 12)

3.2 Installation Standards

The servo amplifier must be installed in a fully enclosed metal control panel. Observe the standards

for mounting servo amplifiers in control panels, including those for the mounting servo amplifiers side

by side in one control panel as shown in the following illustration.

• Servo Amplifier Mounting Orientation

Mount the servo amplifier vertically to the wall, with the fr

ont panel (the side with the panel operator

display)

facing out.

• Cooling

Refer to the following diagram and leave sufficient space for cooling by fans and natural convection.

• Mounting Servo Amplifiers Side by Side in a Control Panel

Leave sufficient space on each side and at the top and the bottom of each servo amplifier. The

width on each side varies in accordance with the models of the servo amplifiers used.

Also install cooling fans above the servo amplifiers to disperse local pockets of warmer air around

the servo amplifiers.

• Inside the Control Panel

The conditions inside the control panel should be the same as the environmental conditions of

the servo amplifier. Refer to the environmental conditions in 2.1 General Specifications

• During Operation

Do not touch the connectors or IO cables during operation if the panel door is open.

30 mm or more

40 mm or more

Fan Fan

Width varies with

servo amplifier model

Servo Amplifier Model SGDV-

Side

Top and bottom

Left Right

R70F, R90F, 2R1F, R70A, R90A, 1R6A, 2R8A 1 mm or more

40 mm or more

2R8F, 3R8A, 5R5A, 7R6A 1 mm or more 10 mm or more

120A, 180A, 200A, 330A, 470A, 550A, 590A, 780A,

1R9D, 3R5D, 5R4D, 8R4D, 120D, 170D, 210D, 260D,

280D, 370D

10 mm or more

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 49 50

Pas de commentaire

Yaskawa MP2600iec Manuel d'utilisateur Page 12