Wiring the Control Circuit
Screwdriver blade width
Insert the wire into the lower part of the terminal block and connect it tightly
with a screwdriver.
Wire sheath strip length must be 5.5mm (0.22in.).
25
* SW7 can be changed according to sequence input signal (S1 to
S5) polarity.
0V common: NPN side (factory setting)
+24 common: PNP side
Refer to page 106 for SW7.
Refer to page 67 for SW8.
• Control circuit terminals
Wiring the control circuit terminals
Pass the cable through wiring hole and connect. Be sure to mount the
covers on its original position.
Only basic insulation is provided for the control circuit terminals.
Additional insulation may be necessary in the end product.
Commentaires sur ces manuels