30
Open the front cover and verify that the strip length is 5.5mm (0.22in.).
Wiring Inspection
After completing wiring, check the following :
▫ Wiring is proper.
▫ Wire clippings or screws are not left in the unit.
▫ Screws are securely tightened.
▫ Bare wire in the terminal does not contact other terminals.
If the FWD (REV) run command is given during the run command selection
(n003=1) from the control circuit terminal, the motor will start automatically
after the main circuit input power supply is turned ON.
Commentaires sur ces manuels