YASKAWA Inverter Manuel d'utilisateur télécharger pdf (Page 74)

Digital Operator 3 - 5

 REMOTE Reference (REF) Indicator

The status of the “REMOTE” Reference (REF) indicator is shown in Table 3.4. This indicator is always “Off” when the Drive

is in the “LOCAL” mode. When the Drive is in the “REMOTE” mode, the REF indicator status is dependent on the setting of

parameter b1-01 (Frequency Reference Selection). See Table 3.4.

 Run Indicator

The status of the “RUN” indicator is shown in Table 3.5 when the Drive is in either the “LOCAL” or “REMOTE” mode.

 Stop Indicator

The status of the “STOP” indicator is shown in Table 3.6 when the Drive is in either the “LOCAL” or “REMOTE” mode.

Table 3.4 REMOTE Reference (REF) Indicator

Indicator Status Condition

Parameter b1-01 (Frequency Reference Selection) is set to terminal strip, communications, option

board, or pulse train as indicated below:

b1-01=1 (Terminals)

=2 (Communications)

=3 (Option PCB)

=4 (Pulse Train)

Off

Parameter b1-01 (Frequency Reference Selection) is set to digital

operator as indicated below:

b1-01=0 (Operator)

Table 3.5 RUN Indicator

Indicator Status Condition

On Drive is running.

Blinking Drive is decelerating to a stop.

Off Drive is stopped.

Table 3.6 STOP Indicator

Indicator Status Condition

Drive is decelerating to a stop or stopped.

Blinking

Drive is in a run condition but the frequency reference is less than the

minimum output frequency E1-09, or the Drive is running in “REMOTE” mode and the “STOP”

key on has been pressed.

Off

Drive is running.

1 2 ... 69 70 71 72 73 74 75 76 77 78 79 ... 254 255

Pas de commentaire

YASKAWA Inverter Manuel d'utilisateur Page 74