YASKAWA Inverter Manuel d'utilisateur télécharger pdf (Page 83)

Digital Operator 3 - 14

Use and keys to scroll through the “Auto-Tuning” parameter list. Depending on the Control Method (A1-02)

setting, only certain Auto-Tuning parameters will be accessible. See table below.

After setting Auto-Tuning parameters according to motor nameplate specifications, press so that the following screen

appears on the Digital Operator.

Press the RUN key on the Digital Operator to start Auto-Tuning. The motor will automatically run. During this process the

motor parameters will be automatically set in the Drive according to the measured values.

Table 3.13 Auto-Tuning Parameter List

Auto-Tuning Parameters Control Method

V/F V/F w/PG OLV Flux Vector

T1-01 Tuning Mode Selection O O O O

T1-02 Motor Rated Power O O O O

T1-03 Rated Voltage X X O O

T1-04 Rated Current O O O O

T1-05 Rated Frequency X X O O

T1-06 Number of Poles X X O O

T1-07 Rated Speed X X O O

T1-08 PG Pulses/Rev X X X O

O = Accessible

-A.TUNE- Rdy

Auto-Tuning

- - - - - - - - - - - - - - - - - - - - - - - - - - - - -

0Hz/ 0.00A

Tuning Ready ?

Press RUN key

1 2 ... 78 79 80 81 82 83 84 85 86 87 88 ... 254 255

Pas de commentaire

YASKAWA Inverter Manuel d'utilisateur Page 83