YASKAWA VS-606V7 Series Manuel d'instructions télécharger pdf (Page 42)

5. Operating the Inverter

 Te st R u n

The Inverter operates when a frequency (speed) is set.

There are four operating modes for the VS-606V7:

1. RUN command from the Digital Operator (potentiometer/digital set-

ting)

2. RUN command from the control circuit terminals

3. RUN command from MEMOBUS communications

4. RUN command from comunication card (optional)

Prior to shipping, the Inverter is set up to receive the RUN command

and frequency reference from the Operator. Below are instructions for

running the VS-606V7 using the JVOP-140 Digital Operator (with

potentiometer). For instructions on operation, refer to page 51.

Operation reference or frequency reference constants can be selected

separately as shown below.

Name Constant

RUN

Command

Selection

n003 = 0 --- Enables run, stop, and reset from Digital Operator.

= 1 --- Enables run and stop from control circuit terminals.

= 2 --- Enables MEMOBUS communications.

= 3 --- Enables communication card (optional).

Frequency

Reference

Selection

n004 = 0 --- Enables the Digital Operator’s potentiometer setting.

= 1 --- Enables Frequency Reference 1 (constant n024).

= 2 --- Enables a voltage reference (0 to 10 V) at the control circuit

terminal.

= 3 --- Enables a current reference (4 to 20 mA) at the control circuit

terminal.

= 4 --- Enables a current reference (0 to 20 mA) at the control circuit

terminal.

= 5 --- Enables a pulse train reference at the control circuit terminal.

= 6 --- Enables MEMOBUS communications.

= 7 --- Enables a voltage reference (0 to 10 V) at the Digital Operator’s

circuit terminal.

= 8 --- Enables a current reference (4 to 20 mA) at the Digital Operator’s

circuit terminal.

= 9 --- Enables communication card (optional).

1 2 ... 37 38 39 40 41 42 43 44 45 46 47 ... 217 218

Pas de commentaire

YASKAWA VS-606V7 Series Manuel d'instructions Page 42