YASKAWA Inverter Spécifications télécharger pdf (Page 116)

5.8 n: Special Adjustments

The n parameters handle a variety of specialized adjustments and functions, including Hunting Prevention.

n1: Hunting Prevention

Hunting Prevention keeps the drive from hunting as a result of low inertia and operating with light load.

n1-02: Hunting Prevention Gain Setting

Sets the gain for the Hunting Prevention Function.

No. Name Setting Range Default

n1-02 Hunting Prevention Gain Setting 0.00 to 2.50 1.00

Normally, n1-02 does not need to be changed, but adjustment may help under the following conditions:

•

If the motor vibrates while lightly loaded increase the gain by 0.1 until vibration ceases.

• If the motor stalls decrease the gain by 0.1 until the stalling ceases.

n3: Overexcitation Deceleration

Overexcitation deceleration increases the flux during deceleration and allows shorter deceleration time settings than with

normal deceleration without the use of a braking resistor. Enabled by setting L3-04 = 4.

Notes on Overexcitation Deceleration

• As regenerative energy is mainly dissipated as heat in the motor, the motor temperature will rise if overexcitation deceleration

is applied frequently. In such cases, make sure the motor temperature does not exceed the maximum allowable value or

consider using a braking resistor option instead.

• The drive decelerates at the active deceleration time. Make sure to set this time so that no overvoltage (ov) fault occurs.

• When a Run command is entered during overexcitation deceleration, overexcitation operation is cancelled and the drive will

reaccelerate to the specified speed.

• Do not use overexcitation deceleration in combination with a braking resistor option.

Use parameter n3-13 for adjusting overexcitation deceleration.

n3-13: Overexcitation Deceleration Gain

Applies a gain to the V/f pattern output value during overexcitation deceleration, thereby determining the level of

overexcitation. The drive returns to the normal V/f value after the motor has stopped or when it is accelerating to the frequency

reference.

No. Name Setting Range Default

n3-13 Overexcitation Deceleration Gain 1.00 to 1.40 1.10

The optimum setting for n3-13 depends on the motor flux saturation characteristics.

•

Increase the gain by 1.25 to 1.30 to improve the breaking power of overexcitation.

• Reduce the value when the motor slip gets too high, which can trigger overcurrent (oC), motor overload (oL1), or drive

overload (oL2) faults.

5.8 n: Special Adjustments

116

YASKAWA ELECTRIC SIEP C710606 31A YASKAWA AC Drive – J1000 Technical Manual

1 2 ... 111 112 113 114 115 116 117 118 119 120 121 ... 241 242

Pas de commentaire

YASKAWA Inverter Spécifications Page 116