Yaskawa DeviceNet Option Card CM05x Manuel d'utilisateur télécharger pdf (Page 17)

Setup and Installation 3-2

Option Board Hardware Components

CAUTION

The DeviceNet Option Board is an electrostatic sensitive device. Personnel

must follow approved methods for handling this type of equipment.

WARNING

Hazardous voltage may cause severe injury or death. Ensure all power sources

feeding the Drive are locked in the “OFF” position before installing this option board.

Figure 3.1 shows the DeviceNet Option Board. J1 connector (on back of board) is used for connection to the

2CN connector on the Drive. DIP switches are used to set up the DeviceNet network Baud Rate and the

DeviceNet MAC ID. The DeviceNet terminal is used for connection of the DeviceNet network wiring. Ground

wire is the ground connection to the Drive terminal board. NS is the Network Status LED and MS is the Module

Status LED.

Figure 3.1 DeviceNet Option Board

DIP switches

MS LED

NS LED

DeviceNet

Terminal

Ground wire

1 2 ... 12 13 14 15 16 17 18 19 20 21 22 ... 113 114

Pas de commentaire

Yaskawa DeviceNet Option Card CM05x Manuel d'utilisateur Page 17