Yaskawa DeviceNet Option Card CM05x Manuel d'utilisateur télécharger pdf (Page 18)

Setup and Installation 3-3

Option Board Setup

The DeviceNet Option Board requires setup prior to operation. DIP switches must be set prior to the application

of input AC power to the Drive. The states of these DIP switches are read only on power-up.

Option Board DIP Switch Settings

The DIP switches are used to setup DeviceNet network characteristics. The DIP switch functions are defined in

the following table:

DIP Switch Number Function

1 Baud Rate, Bit 1

2 Baud Rate, Bit 0

3 Node Number, MSB

4 Node Number

5 Node Number

6 Node Number

7 Node Number

8 Node Number, LSB

9 Not Used

10 Master Idle Operation

DIP switches 1 and 2 are used to select the baud rate of the DeviceNet network. The baud rate setting of the

Option Board must match the baud rate setting of the rest of the devices on the DeviceNet network. The

available baud rates are defined in the following table. The cable distance between any two points in the cable

system must not exceed the Maximum Cable Distance allowed for the baud rate selected. See Chapter 4 for

information on calculating the Maximum Cable Distance.

DeviceNet

Baud Rate

DIP Switch Position

(KBaud) Switch 1 Switch 2

125 Off Off

250 Off On

On Off

500

On On

1 2 ... 13 14 15 16 17 18 19 20 21 22 23 ... 113 114

Pas de commentaire

Yaskawa DeviceNet Option Card CM05x Manuel d'utilisateur Page 18