Yaskawa iQpump Controller Programming Manual Manuel d'utilisateur télécharger pdf (Page 106)

106 YASKAWA TM.iQp.07 iQpump Controller Programming Manual

■

Broadcast Data

The following table shows the broadcast data. Broadcast Data Can Be Written (function Code 06 / 10) only.

Table 39 Broadcast Data

■ Enter Command

When writing parameters to the iQpump drive from the PLC using MEMOBUS / Modbus communication, the parameters are

temporarily stored in the constant data area in the drive. To enable these parameters in the parameter data area, use the Enter command.

There are two types of Enter commands:

1. Enter commands that enable parameter data in RAM

2. Enter commands that write data to EEPROM (non-volatile memory) in the iQpump drive at the same time as enabling data in RAM.

The following table shows the Enter command data. Enter command data can only be written.

The Enter command is enabled by writing 0 to register number 0900 or 0901.

Table 40 Enter Command

Important: The maximum number of times the EEPROM can be written using the iQpump drive is 100,000. Do not frequently execute

Enter commands (0900) written to EEPROM.

The Enter command registers are write-only. Consequently, if reading these registers, the register address will become invalid (Error

code: 02).

0001

Operation signal

Bit 0 Run forward 1: Run 0: Stop

Bit 1 Reverse operation command 1: Run 0: Stop

Bits 2 and 3 Not used

Bit 4 External error (1: Fault set using H1-01)

Bit 5 Error (Fault 1: Reset commandset using H1-02)

Bits 6 ~ B Not used

Bit C Multi-function digital input terminal S5 input

Bit D Multi-function digital input terminal S6 input

Bit E Multi-function digital input terminal S7 input

Bit F Not used.

0002 Frequency reference 30000 / 100%

Note: Bit signals not defined in the broadcast operation signals use local node data signals continuously.

0900 Write parameter data to EEPROM

0910 Parameter data is not written to EEPROM, but refreshed in RAM only.

1 2 ... 101 102 103 104 105 106 107 108 109 110 111 ... 301 302

Pas de commentaire

Yaskawa iQpump Controller Programming Manual Manuel d'utilisateur Page 106