Yaskawa iQpump Controller Programming Manual Manuel d'utilisateur télécharger pdf (Page 139)

YASKAWA TM.iQp.07 iQpump Controller Programming Manual 139

o3 Digital Operator Copy Function

◆ o3-01 Copy Function Selection

Note: The copy function is disabled when serial communication is active.

◆ o3-02 Read Allowed Selection

The digital operator has parameter COPY capabilities via built in non-volatile memory. The digital operator can READ all of the

parameters in the iQpump drive and store them for later WRITE back to the iQpump drive or into an iQpump drive with the same product

code and software number. In order to read the parameter values and store them in the digital operator, select o3-02 = “1: Enabled”. If an

attempt is made to READ the data, which overwrites previously stored data, without first setting o3-02 = “1: Enabled,” the following

error will occur:

After setting o3-02 = “1: Enabled,” it is possible to store parameter values in the digital operator by setting o3-01 = 1 (INV→ OP

READ).

A successful READ of the parameter values will display:

An error may occur while saving the parameter values to the digital operator’s memory. If an error is displayed, press any key to cancel

the error display and return to parameter o3-01. Error displays and their meanings are covered in Chapter 6: Diagnostics and

Troubleshooting of the iQpump User Manual (TM.iQp.06). To COPY parameter values into a drive, set o3-01 = “2: OP→ INV WRITE”.

During the writing of the parameter values into the iQpump drive the digital operator will display:

Setting Description

0 COPY SELECT (factory default)

1INV

→ OP READ

2OP

→ INV WRITE

3OP

↔ INV VERIFY

Setting Description

0Disabled (factory default)

1 Enabled

-ADV-

PRE

READ IMPOSSIBLE

-ADV-

READ

READ COMPLETE

-ADV-

COPY

OP → INV COPYING

1 2 ... 134 135 136 137 138 139 140 141 142 143 144 ... 301 302

Pas de commentaire

Yaskawa iQpump Controller Programming Manual Manuel d'utilisateur Page 139